The guys at home depot had a lot of fun lamenting the fact that the hole existed to begin with and then suggested that i build a mold on one side of the wall and fill it in with a pour of concrete.
Filling surface voids in concrete walls.
But there s nothing typical about the recommended approaches to repairing these voids.
Most of these water drops come form the mixing water but some are introduced from the cavities of the moist aggregate particles form which they are forced during vibration.
Tip 6 use the correct release agent for the removal of the concrete from the moulds.
Water similar to release agents water is also trapped against the mold s working surface resulting in voids.
When a release agent is over applied it may pool or puddle on the lower extremities of the mold and when concrete is poured these pools prevent the concrete from filling in 100.
Honeycomb repair in concrete surface honeycomb and larger surface voids require procedures resembling those for typical concrete repairs.
While repairing voids or honeycomb in concrete surface the most common question that arises is what should be the thickness of the.
Causes perhaps the most influential cause of bugholes is improper vibration.
While many variables must be considered in the elimination of surface voids or bug holes in concrete castings there are a number of precautions that can remedy this unsightly problem.
However problems do arise if the concrete surface is to be painted or if the voids reach a larger diameter typically greater than 1 inch.
Aci 301 05 specifies two as cast surface finishes.
I ve never used it but i imagine applying it with a trowel would be the ticket.
These surface voids are primarily an aesthetic problem for exposed structural concrete.
Go to your favorite home store and get a sack of stuff called parge it s used to fill in rock pockets on formed concrete placements such as walls.
Voids are created when concrete is partially supported by base soils or through the use of anchors or rebar to foundation walls or through the use of sonotubes.
After hearing that i seriously considered just gluing a piece of plywood over it and calling it a day.
Next time as was mentioned pour it wetter and smack the forms with a hammer.
Careful preparation and methodical practices can eliminate even the worst of surface voids.
How to eliminate voids in a concrete casting.
The water later evaporates to leave voids.
The permissible number and size of bug holes in a concrete surface is not defined in either aci 301 05 or aci 301 10 specifications for structural concrete in fact aci 301 05 does not limit either the number or size of surface voids in as cast surface finishes.
