Covered under signature hardware s limited lifetime warranty made of 16 gauge 304 grade stainless steel wall mounted installation sink will install against a wall sink features dual basins with a 50 50 split handcrafted with.
Fitting a wall mounted washbasin.
Other procedures are common to most sinks.
It features a large backplate to keep water in your sink and off your walls signature hardware 340617 features.
Mark the supply tube lengths by holding them alongside the valves photo 14.
Cut the copper lines off 1 in.
For a hollow wall or stud wall you need to ensure that the fixings go into the wooden studs.
Be sure to use a masonry bit if you re drilling through tile.
Installing a wall mount sink usually involves uncovering the wall so you can install blocking to support the sink.
You cannot just use plasterboard wall fixings in this case.
Mount the sink to the wall.
Past the wall and slip on compression fitting valves with the water feeds facing up but don t fully tighten the nuts yet.
Toilet sink units.
Set the basin onto the wall anchors and fit the flanged collar sleeve washer and nut in this.