Flip the panel over.
Fitting bathroom wall panels over tiles.
Remove baths protective film before sealing bath to wall.
Can you put bathroom wall panels over tiles.
Insert the supplied sealant tube into a caulk gun.
This stuff is great to fit because it s very quick and reduces the points for a.
Installing pvc panelling over existing bathroom wall tiles.
How to fit shower wall or bathroom board in your home as a tile alternative.
Measuring up to fit your shower panels.
What surfaces can bathroom wall panels be fitted on.
Wall panels can be fitted over multiple surfaces like tiles and plasterboard.
You can also fit shower panels directly over existing tiles or wall coverings.
Yes you can install wall panels over your existing tiles.
Just use our recommended adhesive to fit the panels straight over your tiles.
Take your panel and lay it flat on supports with the front facing up then mark out the cutting lines on.
Peel the paper backing off of the foam tape on the back of the panel and position the panel over the tile.
Fitting shower seats or grab rails to this type of paneling is not recommended as the panelling can crush as the fittings are tightened up to it.
However shower wall panels are a little more forgiving with uneven surfaces.
This includes both horizontally and vertically.
Main advantage of shower panels over tiles.
Eliminate the hassle of tile grout joints once and for all.
In a domestic environment pretty much the same as what other wall cladding materials like tiles can be fitted on.
Measure the area where the wall panels will be fitted.
There s no need to remove your tiles just slot them in place and your bathroom refresh is underway.
Another reason wall panels are a better choice than traditional tiles are waterproofing and maintenance panels are much easier to look after.
Make sure the walls are vertical.
Just because a bathroom is tiled doesn t mean you can panel it.
The panels are tongue and grooved so they just slot together to give you a waterproof surface.
If they are not you will need to cut the edge of the shower panel that fits into the corner at an angle to ensure that the other edge is vertical.
Apply a bead of sealant onto the panel keeping it about 1 inch in from the foam tape around the perimeter.