Do not open door select drain spin to remove water restart cycle.
Frigidaire affinity washer door open error.
There is the striker plate on the door itself which can crack or get jammed.
Factory trained appliance technician with 20 years of in home appliance repair experience.
Repairing a frigidaire affinity front loading washer.
Before tumbling starts you can stop the washer and then wait for the water to drain off the window before opening the door.
The parts needed to make this repair are linked below.
When i emailed parts pros and asked if could be the mother board they said just to change the swtich.
Washers dryers refrigerators freezers dishwashers etc.
This should disable the lock.
The lock on the washer has three parts any of which can malfunction.
My washer out of the blue says that the door is open when it is shut.
Washer motor stops if overheated.
Cold water hose is connected to.
On a front load washer the door will be locked during the entire wash cycle.
You should now be able to pry the washer s door open to add clothes or remove items.
But now when i try to start the washer with or without any clothes in it i get the time of the wash cycle and pau blinking back and forth.
I have a frigidaire affinity front load washer fafw3801lw3.
I ve replaced the door lock.
Be sure to verify with the parts company the correct control board for your model washer.
To complete the frigidaire front load washer door latch bypass can be quickly done by pressing the control lock button for five seconds.
Frigidaire affinity washer error e41 troubleshooting.
This video demonstrates the proper and safe way to disassemble a washing machine and how to access part.
Wait 30 minutes for motor to cool down.
Push the start pause button to stop the current wash cycle.
Frigidaire affinity washer how to exit diagnostic mode chart.
So i did what i seen on here and checked the striker then replaced the door lock switch.
There is the door latch which can fracture or get jammed.
Washer will not operate if the door is open.
Locate the j2 plug on the console control board and measure voltage from the black wire to the ground with power on.
The diagnostic test is performed by using the program knob.
To open it simply stop the washer and wait 1 to 3 minutes for the safety lock to open.
